Flo-Thru Heater Element
If your spa fails to heat the water properly, the heater element
should always be checked.
Defective elements that have been damaged by poor water balance
usually trips the GFCI when the heat comes on. Elements that have
just stopped working just don’t heat.
Most heater elements go bad because of improper water chemistry. To
help you improve your water chemistry, we recommend the book,
Spaaaahhhhhh The Owner's Guide to Understanding Spas and Hot Tubs
.
Regardless of the age of your spa pack, if the only thing broken is
the heater element, the economical thing to do is to replace the
heater element.
Our heater element fits all Nu Wave spa packs, or for any pack that
takes a universal hi-flo element. You can select between a 5.5 kw
or a 4.0 kw for 220V application. For 110V application the 5.5 kw
heater element outputs 1.5 kw, and the 4.0 kw heater element outputs 1.0 kw.
5.5 kw = 18766 BTU
4.0 kw = 13648 BTU
Heater Elements that we provide are OEM Factory Replacement Parts and made in the U.S.A.
These heater elements are USA and Canada Underwriters Labortories
listed for your safety.
Dimension: 10 inches long, 1.37 inches across and fits in a 15 inch long Flo-Thru
heater tube that is at least 2 inches in diameter. The distance between
the heater terminals from center point is 1.25 inches.
(View Diagram)
To determine whether a universal element will work in your
controller, remove your existing element from the controller. If the
element has two probes on it that drop into the control box and has
the same shape as the one above, then it will work in your
controller. If it does not look the same, it is not a universal
element and will not work.
Looking to replace the entire heater metal housing? Check out our complete
Heater Assembly.
NOTE: It is recommended to use similar wattage heater element as the
original previously installed to avoid unforeseen problems.
Heater Element Type
Standard Incoloy: This is the standard type heater element primarily
used in most spa controllers in the after-market and OEM controller or
packs. Comes with 1-year limited warranty.
Teflon Coated: Special protective coating that is applied on the heater
element to help keep the heater element lasting longer from bad water in
the spa or hot tubs. Also helps keep the heater element for corrosion
and scale formation. Also used in some after-market and OEM controller
or packs. Comes with 2-years limited warranty.
Titanium: Heater elements made out of Titanium metal. It provides the
best heat to water transfer. This type of heater element can be used
with salt water application. It's made to withstand many water
conditions that other heater elements can't. Titanium is known to be the
most non-corrosive, longest lasting, and not too many particles will
stick to it. Also used in some after-market and OEM controller or packs.
If you are having a lot of trouble maintaining the spa or hot tub water,
then this heater element is for you. Comes with 5-years limited warranty.
|