Special Sale!  
Spas2Order BBB Business Review
cards NoTax

Pump Pot

Pump pots, also known as Leaf Traps, are needed when the spa pump is mounted near or slightly above the water line. The pot helps prevent water from draining back into the spa when the motor is turned off.

SpaGuts P/N:

  • 15-350-1105, 310-5400, 1.5"
  • 15-350-1110, 310-6600, 2.0"

Even if pumps are installed below the water level, installing a pump pot helps in many ways. Pump pots also help remove air from the water lines, and helps the pump provide consistent water flow. Most spas don't have all the water flowing through the filter. There is a strainer inside the pump pot to help prevent leaves, rocks, or large debris from entering into the pump housing that can damage internal parts. Our pump pots are manufactured by Waterway Plastics.

Dimensions (Approx.): 10.5 inches H x 8 inches diameter

There are 2 sizes. Select the size that will screw onto your pump intake.

If your spa has 2 pumps, you need a pump pot for each pump that is mounted near or above the water line.

NOTE: This pump pot is to be installed with a spa pump mounted near the spa, not more than 5 feet away and not more than 0.5 foot above the water level. Otherwise an in-ground pool pump is needed.

$70.00 In Stock PumpPotM.jpg

This item has options that require your selection below. Please make a selection for each option
Hover on Learn More to read about the respective option.
Size of Pump Union Fittings
The diameter size of the fittings will be either 1.5 inches or 2 inches and both may not be the same, so it is important to measure each of them. Use a tape measure to determine the correct size of fittings needed.
Learn More
After selecting from EACH option above...