Waterway Spa-Flo Pump Wet End ASSY

Replacement 1.5 inch pump wet end assembly for the Waterway Spa-Flo Side Discharge 48-Frame Pump model. Available in 1.0, 1.5 and 2.0 HP. Both intake and discharge fittings are 1.5 inch.

SpaGuts P/N:

  • 1.0HP 15-350-0700, 310-0700
  • 1.5HP 15-350-0800, 310-0800
  • 2.0HP 15-350-0810, 310-0810

The 1.5 inch pump wet end assembly has an outside to outside thread measurement of approximately 2.5 inch (or 2-3/8inch).

NOTE: Only purchase this pump wet end assembly as a direct replacement to avoid leaks, fitment and failures. Do not install on 56-Frame motors.

This item comes with a 90-Day limited warranty. This item is non-returnable.

$115.00 In Stock Spa-Flo_WetEnd_M.png

This item has options that require your selection below. Please make a selection for each option
Hover on Learn More to read about the respective option.
Size of Pump Motor
Size of Pump Motor: Determining the right size of motor for your spa is crucial, but easily determined. You should consider the horsepower of the motor that is currently on your spa and replace it with a similar size if you are happy with its operation. As a general rule you should have 1 horsepower for every 4 jets. Over powering your jets with too much horsepower could cause damage to your plumbing, damage your equipment or inflict bodily injury, so it is important to get the right size motor for your application.
Learn More
1.0 HP
1.5 HP
2.0 HP
After selecting from EACH option above...