Hydro Quip CS6200-EX Export 50Hz Electronic Spa Controller Kit w/Topside, 3.0KW Heater

Hydro Quip CS6200-EX Export 220V 50Hz Electronic Spa Controller Kit with Topside Panel and a Flo-Thru 3.0KW Heater. Normally used for International Spa Application with 220V 50hz electrical ratings.

SPECIAL ORDER NOTES: THIS ITEM IS A SPECIAL ORDER AND HAS AN ESTIMATED 10-20 BUSINESS DAYS LEAD TIME BEFORE SHIPPING. SPECIAL ORDERS ARE NON-RETURNABLE AND CANNOT BE CANCELED ONCE THE ORDER IS PLACED.

SpaGuts P/N: 10-150-1720

Power Requirement:

• Single Service (3 wires - Line, Neutral, Ground)
  230V, 50Hz, 1~, 1 x 16A, (Circuit breaker rating = 20A max)

• Single Service (3 wires - Line, Neutral, Ground)
  230V, 50Hz, 1~, 1 x 32A, (Circuit breaker rating = 40A max)

• IMPORTANT - Service must include a neutral wire, with a line to neutral voltage of 230V

Features:

• Water Resistance topside panel that easily mounts to the topside of your spa
• Compact Size. Control Box Dimensions are (Approx): 12.5 inches long x 10.25 inches high x 4.13 inches deep.
• Heater Dimensions are (Approx): 15 inches long x 2 inches in diameter
• Foot mount brackets for simplified installation and Easy Heater Removal
• 3.0KW, 240V Flo-Thru Stainless Steel Heater with Heater ON light and reversible water flow
• Pump 1 circuit, 2-Speed, 240V, 15A Max
• Blower circuit, 1-Speed, 240V, 8A Max
• Ozone circuit, 240V, 2A Max
• Circ. Pump circuit, 240V, 5A Max (Optional)
• 12 volt light that plugs into most existing sockets
• 48 inch amp motor, blower and ozone cords
• Canadian and United States UL Recognition (cURus) and Edison Testing Laboratories (ETL) listed for your safety
• Freeze protection
• High-limit protection
• Pressure switch to ensure that the heater comes on only when water is flowing.
• Temperature sensor probe
• 1-year manufacturer's limited warranty

Topside Panel

Topside Panel will have 4 buttons (jets, blower, light, temp up/down), approximate dimensions of 5 inches x 2.5 inches, and comes with an approximate 10ft cord. The topside display have a red LED temperature readout so you can easily read the temperature from either inside or outside the spa. If your new topside controller is smaller than your existing hole cut-out, you can install an Acrylic Placard to cover up the larger hole.