Hydro Quip CS6334-U-LF Electronic Spa Controller Kit w/Topside, 4.0KW Tubular Heater

Hydro Quip CS6334-U-LF Electronic Spa Controller Kit with Topside Panel and an attached 4.0KW Lo-Flo Tubular Heater.

THIS ITEM IS NO LONGER AVAILABLE. IT HAS BECOME OBSOLETED BY THE MANUFACTURER.PLEASE SEE PART NUMBER 10-150-6334 AS THE REPLACEMENT OPTION.

SpaGuts P/N: 10-150-9334

Features:

• Hydro Quip CS6334-U-LF Electronic Spa Controller
• Water Resistance K-35 Topside Panel with 10ft Cable
• *Topside Overlay: JET1-JET2-AUX-LIGHT-UP-DOWN
• Topside Cover Plate and Sticky Gasket, 8.5" x 3.5"
• Attached 4.0KW 220V Lo-Flo Tubular Heater, 26-0091B-F1 (Rated 1.0KW on 110V)
• Foot mount brackets for simplified installation
• 110 or 220 volts Component Circuits
• Pump 1 circuit, 2-Speed, 120/240V, 13A Max
• Pump 2 circuit, 2-Speed, 120/240V, 13A Max
• Blower circuit, 1-Speed, 120/240V, 8A Max
• Ozone circuit, 120/240V, 2A Max*
• Circ. Pump circuit, 120/240V, 5A Max*
• Light Harness with 12V 12W Clear Light Bulb, 8ft Cable
• Color-coded 48-inch Red Pump 1, Brown Pump 2, Blue Circ Pump, Violet Blower and Yellow Ozone cords with matching color-coded interlocking receptacles
• Canadian andUnited States UL Recognition (cURus) and Edison Testing Laboratories (ETL) listed for your safety
• Freeze protection
• High-limit protection
• Flow Switch for water flow detection (Heater Input Must be installed on Discharge side of Pump)
• Filtration mode
• Temperature sensor probe
• Thru-Wall Thermowell
• Hose Barb Adapter
• Hose Clamps
• Short 3/4" Clear Tubing
• Installation and Operation Instructions, 85-USERIES-HQ
• 1-year manufacturer's limited warranty

Topside Panel and Accessories

Topside Panel will have 6 buttons (jet1, jet2, blower, light, temp up, temp down), approximate dimensions of 7 inches x 3.25 inches, and comes with an approximate 10ft cord. The topside display have a red LED temperature readout so you can easily read the temperature from either inside or outside the spa. If your new topside controller is smaller than your existing hole cut-out, you can install an Acrylic Placard to cover up the larger hole.

Accessorry Bag Contents:

Dimensions:

• Controller with Heater (Approx): 26.5 inches L x 10.25 inches H x 7.0 inches D
• Topside Panel (Approx): 7.0 inches long x 3.25 inches wide
• Heater Dimensions (Approx): 26.5 inches L x 6.0 inches H
• Control Box Dimensions (Approx): 12.25 inches L x 4.00 inches W x 10.25 inches H

This controller kit is also known as the following part numbers: CS9334-U-LF

*NOTE that the color layout of the Topside Overlay may vary upon availability.