Aqua-Flo Flow-Master XP2 Spa Pump, Gecko OEM brand. Rated 2.0 Break Horse Power (BHP), 1.5 Horse Power Continuous (HP), 220V, 2-Speed, 7.7A/2.2A, 60Hz, 48-Frame. OEM part number 06115517-2040.
This is a Gecko OEM brand Aqua-Flo Flow-Master XP2 Spa Pump. The pump wet end and motor will have Gecko Labels on them indicating the Original Equipment.
NOTE: The pump photo shown to the right only shows one capacitor mounted on top of the motor. We cannot guarantee if the motor that is shipped will have 1 or Dual Capacitor attached to the outside of the motor housing, and at a specific location due to different motor models that are supplied. Make sure there is plenty of room where the spa pump is located for a motor that may have a single of dual motor capacitor on the outside of the motor housing.
SpaGuts P/N: 15-720-5517
Pump and Motor Ratings
- Pump Wet End Model: XP2
- 2.0" Center Suction
- 2.0" Side Discharge
- Outside Threads Diameter: 3.1" (Approx)
- Horse Power: 1.5HP Continuous
- Motor Cord: None
- Motor Brand: Any
- Voltage: 230V
- Amps: 7.7A/2.2A (Varies by Motor)
- Frequency: 60Hz
- RPM: 3450/1725
- Speed: Dual
- Pump Dimensions (Approx): 15.5" L x 7.75" H x 7.5" W.
- Type: Indoor
- Usage: Above Ground Pool and Spa
This is a Side Discharge Pump with 2.0" fittings. Outside thread to outside thread measurement on the pump fittings is approximately 3.0". (Pump Unions sold separately)
Motor part numbers that are normally used for this pump: T55CXBLH-961
Also known as pump model 065115517-2.
The pump image shows the pump discharge on top pointing to the 12 o'clock position. The pump discharge can also be rotated every 90-degrees (3, 6 or 9 o'clock positions) by loosing the four long bolts at the back of the motor. The pump intake (suction) is located in the front center face of the pump.
This pump is also the replacement option for the following spa pump part numbers: 06614000, 06115, 1-00-0131, 06115005-1040, 06115474-2 (115/230V; Must confirm voltage setup on motor), 06115485-2, 06615883-1, 06615080-1, 06615398-2, 06615485-2, wavemaster 71699 or wavemaster 7000 or wavemaster 36675 (1.65HP - single speed, 220V Configuration ONLY), 06110000-1, 06110291-0, 6110, 06110001-1 (1.0HP), 06110005-1 (1.0HP), 06110000-1 (1.0HP), 06110291-0 (1.0HP), 6110 (1.0HP), 06110-230 (1.0HP), 06110080-1040 (1.0HP), 06615685-2, 15-200-5517, 7-177615-02 (230/115V Motor ONLY; MUST confirmed voltage configuration, and Pump Wet End Model), 06615978-2, 05515661-1 (1.5HP 230/115V; MUST confirmed voltage configuration), 06115517-2040B, 06515880-1 (230/115; MUST confirm voltage configuration), 06115006-5
This XP2 Pump is also the replacement option for the "Relia-Flo" pumps by Caldera Spas. Verify motor amp rating and voltage, the pump discharge type and size fitting to match. Note that the new motor will not have the back end cover with heat vent/exhaust connection. In case the original motor does have it, the original motor back end cover with heat vent connection may be installed on the new motor if it fits. Otherwise retrofitting a heat vent onto the new motor is required only if it is needed. Replacement option for the following pump model numbers: 72991, 06110181-1, 72992, 06015732-1, 06015182-1, 0974101-02, 06115181-1, 06115734-1, 06010182-1, 06015423-2 (1.5HP 230/115V; MUST confirmed voltage configuration), 0974001 (1.5HP Wavemaster), C55MWKBT4824 (1.5HP 230V; MUST confirmed Pump Wet End), watkins 6500 Jet Pump
This item comes with a two year manufacturer's limited warranty.