Flo-Thru Heater Element for Export Application, Universal, 2.0KW, 220V

Replacement 2.0KW 220V Incoloy Universal Flo-thru Heater Element.  Normally used for Export 50Hz Spa Controllers.  Assembled in USA!

An order includes ONE heater element, TWO heater terminal nuts, TWO heater o-rings, and TWO heater jam nuts.

SpaGuts P/N:  25-150-1206

If your spa fails to heat the water properly, the heater element should always be checked.

Defective elements that have been damaged by poor water balance usually trips the GFCI breaker when the heater comes on.  Elements that have just stopped working just don't heat.

Most heater elements go bad because of improper water chemistry, improper installation, and low water flow.  To help you improve your water chemistry, we recommend to maintain water chemistry and keeping it balanced.  Make sure to use a 1/4-inch open wrench to hold onto the heater terminals, which keeps the heater terminals from turning and breaking the epoxy and damaging the heater element.  And make sure to bleed air out of the water lines prior to activating the heater to avoid a burn out.

Regardless of the age of your spa pack, if the only thing broken is the heater element, the economical thing to do is to replace the heater element.

This replacement heater element fits any spa controllers or spa packs that takes a universal hi-flo element including products made by Balboa, Gecko, Spa Builders, Hydro Quip, ACC, Acura Spas, Len Gorden, Coleman, Watkins, Dimension One, and many others.  The heater housing must be a Flo-Thru metal tube, at least 12 inches long, and at least 2.25 inches in diameter.  The heater terminals should be more towards one side of the heater tube.

2.0 KW = 6824 BTU

Heater Elements that we provide are OEM Factory Replacement Parts and assembled in the U.S.A.  These heater elements are USA and Canada Underwriters Labortories listed for your safety.

Dimension (Approx):  10 inches long, 1.37 inches across and fits in a 15 inch long Flo-Thru heater tube that is at least 2.25 inches in diameter.  The distance between the heater terminals from center point is 1.25 inches.

To determine whether a universal element will work in your controller, remove your existing element from the controller.  If the element has two probes on it that drop into the control box and has the same shape as the one above, then it will work in your controller.  If it does not look the same, it is not a universal element and will not work.

This heater is also the replacement option for the following heater part numbers:  25-4026-BI, 25-4026, C2200-0812ET-G, C2200-0812-G, 12-0106-K, 12-0106-KG, 12-0106

NOTE:  It is recommended to use similar wattage heater element as theoriginal previously installed to avoid unforeseen problems.

This item comes with 1-year limited warranty, and is NON-Returnable.