Replacement Vico Ultima Spa Pump. Rated 1.5HP 110V 2-speed 48-Frame, Side Discharge, 2.0 inch Intake and Discharge. OEM part numbers VUMX2S11515 and VUMX2S11515B.
NOTE: The pump photo shown above does not show a capacitor mounted on top of the motor. We cannot guarantee if the motor that is shipped will or will not have the capacitor attached on top of the motor. Make sure there is plenty of room under the spa for a motor with 6 inches long x 2.5 inches tall x 2.25 inches wide capacitor on top of the motor.
SpaGuts P/N: 15-175-4054
- Rated 1.5HP, 115V, 13.8/3.8A (*Amp Rating Varies)
- 2-Speed Pump (can also be wired for single speed)
- 48-Frame Motor
- 2.0 inch Center Suction, 2.0 inch Side Discharge
- Replaces most Vico Ultima or Victoria spa pumps with similar amp draw
- UL and CSA certified
- All seals are carbon ceramic with Viton® elastomers for long-lasting performance
- Petite volute and compact 48 frame design allow for easy installation in hard to fit areas
- Whisper quiet operation assures a peaceful spa experience
- For above ground spas
This is a Side Discharge Pump with 2.0 inch fittings. Outside thread to outside thread measurement on the pump fittings is approximately 3.1 inch. (Pump Unions sold separately)
*Amp rating and dimensions may vary depending on the motor brand and model that is used with this pump. Motor brand can be US Motors, AO Smith Century Laser, GE, Etc... Please contact us to verify dimensions if space is very limited for the new pump.
Dimensions (Approx*): 14.75" L x 7.58" H x 6" diam.
Motor part numbers that are normally used for this pump: K48M2A3C1, C48AA70A79R, T55MWCBP-1197, BN50, 7-177803-02, 7-186022-03
This Vico Ultima Spa Pump is also a replacement option for the following pump part numbers: 1016258, 1014054-2HZN, 1014054
The pump image shows the pump discharge on top pointing to the 12 o'clock position. The pump discharge can also be rotated every 90-degrees (3, 6 or 9 o'clock positions) by loosening the four long bolts at the back of the motor. The pump intake (suction) is located in the front center face of the pump.
The pump normally ships from the factory with the discharge pointing "UP" which is the standard position for shipping, but they can be turned or what is called "clocked" into any position (12, 3, 9 or 6 o'clock position). Rotation of the pump discharge can be done in the field, but we recommend having it performed by a professional spa technician who is experienced. Or choose the option to have the pump professionally rotated at the factory before it ships. This is to avoid water leaks and operational problems due to improper removal and installation in the field that will affect the warranty. As you face the front end of the pump wet end, available positions are 12 o'clock (Up), 3 o'clock (Right), 9 o'clock (Left), and 6 o'clock (Down, which is very rare).
If buying this pump for retrofitting, add a pair of pump unions that connects to your pipes which then screws directly onto the pump threaded fittings. O-rings are included with the pump unions.
If buying this pump as an exact replacement that does not require retrofitting, it is highly recommended to replace the pump union o-rings at the same time. Old pump union o-rings may cause leaks that can damage the new pump and affect the warranty.
This item comes with a One Year limited warranty.