Call (714) 764-0013
Gemini Plus II Variable Speed Bath Pump with built-in Air Switch, Model NR4, by Balboa. Rated 1.5HP, 110V, 12.5A, 1.5 inch. OEM part numbers 0060F00C and 0060F88C.
ALSO SEE THE 16-175-0059 GEMINI BATH PUMP WITH NO SWITCH AS AN ALTERNATIVE REPLACEMEN OPTION.
SpaGuts P/N: 15-175-0060
This bath pump is also a replacement option for the following bath pump part numbers: 0060F88C, NR4A-C, 1-00-0221, 34-109-1040, A014E88C, 0014F88C, 0045E88C, 0065F88CC, 5151-211, 0059F88C (no air switch), NL74620DB, Hydro Air NRU2A-C, NR4-C, NRU4-C, 006OF88C, R125A-C, R150VS11C/0072E00C (Obsolete - A new variable speed controller and topside will be needed), 0059F00C / 0059F88C (No Air Switch)
Also a replacement option for the ITT Marlow brand bath pumps.
Failed whirlpool jetted bath tub pumps can be easily replaced with the Gemini Plus II Variable Speed Bath Pump, which fits all whirlpool bath tubs.
The Gemini Plus II Variable Speed Bath Pump is compact and easy to install. It runs quietly. It’s also known to be the most reliable bath tub pump on the market, with a failure rate of less than 0.1%.
If you are replacing an existing bath tub pump, you should replace it with the same or similar horsepower and amp rating as your existing pump, if you are happy with current forcefulness of the water coming out of your jets. Check the markings on the pump you are replacing. In general, bathtub pump motors should have 1 HP for every 4 to 6 standard size jets. More horsepower is not better. Overpowering your jets with too much horsepower could damage your plumbing, your equipment, or even you! So, it is important to get the right sized motor for your bath tub. We offer the following horsepower levels:
For retrofitting, you have the option to add screw-on pump unions which glue directly onto 1.5 inch plumbing. After the unions are glued onto your bath tub’s existing plumbing, the unions screw directly onto the pump’s suction and return fittings. The included o-rings provide a tight seal.
Keep your water hot. Add a bath tub heater.
Bath Tub Heater
Prevent endless running of your pump and heater.
Prevent damage from spraying water. Ensure your bath tub’s water level is above the jets before allowing the pump to run.
Bathtub Water Level Sensor
If your tub is not already equipped with an air button, you’ll need to add an air button to your order. The air button comes with 4ft air tubing that connects to the air switch on the bath pump to turn it on/off.