529. Support: Balboa topside displaying SL or SLP

If the "SLP" or "SL" Message is Alternating with the Water Temperature on the Topside Display, the Spa is Operating in the "Sleep Heating Mode". This is NOT an error message. Note that a Sleep Heating Mode will drop the water temperature 20 degrees below the set temperature. Please see the provided Operation Manual for your Control System if you would like to get out of the Sleep Heating Mode. Changing to the "St" Standard Mode is recommended if you would like the water to be heated up to the set temperature. If the SLP or SL Message is ON Solid (Not Flashing) on the Topside Display, the Spa is Operating in the "Sleep Heating Mode", but there is No current water temperature because the Spa is between Filter Cycles. This is NOT an error message. Note that a Sleep Heating Mode will drop the water temperature 20 degrees below the set temperature. Please see the provided Operation Manual for your Control System if you would like to get out of the Sleep Heating Mode. Changing to the "St" Standard Mode is recommended if you would like the water to be heated up to the set temperature. 1) Instructions for VS300FC5, VS500Z and VS501Z Model Controllers: Mode is changed by pressing the "Temp" key, release and then quickly press on the "Light" key, release. Wait for 10 seconds and check the topside display to see if it ONLY shows the temperature. If so, you are on the Standard Mode. If the Topside display is flashing the Temperature and back to "SL" or "EC", Then repeat the steps above to change the Mode.