Articles by tag "controller"

1. 317. Support: Possible clicking noise from pump motor or controller.
   131
   - First check closely under the spa to ensure the clicking noise is coming from the pump motor or the main spa controller. - If clicking noise is coming from the main spa controller, it is possible that there may be an air lock in the plumbing lines. Contact us if so, so we can send you the ...
2. 323. Support: Air siwtch is sticking or not working on Pneumatic Controller.
   110
   You have reported that one of the air switch on the pneumatic controller is sticking or not working properly. Check the following for troubleshooting: - If any air button is not turning on the jets, blower or light, make sure the air tubing is connected from the bottom end of the air button ...
3. 482. Support: How to install a new replacement temperature sensor on the Electronic Controller.
   131
   Installation of a New Replacement Temperature Sensor: Shut Off Power Completely to the spa or hot tub. If the old temperature sensor is installed, follow that temperature sensor cable to the circuit board. Otherwise refer to the wiring diagram to locate the temperature sensor connection. ...
4. 495. What information do I need to get the correct wiring diagram for the SpaGuts brand Controller?
   107
   Below is the following information that is needed in order for us to send you the correct wiring diagram for the SpaGuts brand Controller. The silver label on top of the SpaGuts Controller box should have the following information. Order Code: Model: Serial: Code
5. 456. Can I use Salt with a SpaGuts or Balboa brand Spa Controllers?
   126
   Any type of Salt, including Epsom Salt, are corrosive to spa heater elements and will cause them to wear out quicker. So don't use any type of salt in the spa water without consulting with the spa equipment manufacturer. Also avoid using spa fragrances that have any type of salt in them. ...
6. 256. Sales: What information is needed to order a spa controller? (Controller Information)
   60
   To configure a spa controller, you must verify that our Spaguts spa controller will fit in the cabinet space under the spa. The dimensions of our spa controllers is approximately 12 inch long x 10 inch high x 4 inch thick. The heater attached to the bottom of the controller is 15 inch long x 2 ...