Articles by tag "topside panel"

1. 162. Support: Command Center not working (Intial Installation).
   132
   There are several reasons why the Command Command is not working, or the display does not light up. - Check to make sure the 6-pin plug is connected to the controller. And make sure there is power being supplied to the spa. NOTE: Our Topside Command Center does not require the flat pin ...
2. 405. Support: Topside installation for the CS-Series and M-Series Electronic Spa Controllers
   108
   TOPSIDE INSTALLATION FOR THE CS-SERIES AND M-SERIES CONTROLLERS: NOTE: An installation manual with wiring diagram are provided with our spa controller kit purchase. Please refer to it, and/or follow the instructions below for topside only purchases. 1) If there is an existing topside hole ...
3. 494. Can I get a new gasket for my old/used topside panel?
   105
   Topside gaskets are not available. We don't carry them and the topside manufaturer also don't provide them for old installations. Trying to remove the old gaskets completely is next to impossible. Installing a new gasket on an old/used topside will not provide full protection and will cause ...
4. 870. Sales: Do you sell only the topside panel?
   98
   Yes, we do sell replacement topside panels. But we really don't recommend replacing just the topside panel. The problem may not just be the topside panel itself. The problem can also be the main circuit board. And a bad circuit board can also cause the new topside panel to go bad. Note that a ...