Spa Blower Check Valve (NON-Returnable)

In stock
In stock

If your spa has a blower, this check valve should be installed in-line between your blower and the spa air plumbing to help prevent water from back-flowing from your spa into your blower (as a secondary protection). This can happen when your blower is turned off causing it to literally siphon water from your spa into the blower. This backflow is not only dangerous, but will likely damage your blower and possibly the spa controller, too.

SpaGuts P/N: 15-450-1010

Check valves should be replaced every 5 years.

NOTE that a blower check valve is to be used as a secondary protection for a small amount of water (one hand full) coming through the air line. The Primary Air Line Trap on the spa plumbing that loops up above the top of the water level should be the primary protection to stop all water from coming through the air line.


  • 1/4 pound spring tension
  • 1.5 inch Slip x 2.0 inch Spigot
  • Our Spa Blower Check Valve fits both 1.5 and 2.0 inch plumbing. Use a 2 inch coupler to fit 2.0 inch plumbing.
  • Fits directly onto spa air blowers with 2.0 inch fittings, such the Ultra-9000
  • Dimensions (Approx): 5 inch long x 2.75 inch in diameter.

This item is also a replacement option for the following part numbers: CO-0106, 1112500, 0830-15C, 42-0078

This item comes with a one year limited warranty, and is NON-Returnable.

Write Your Own Review
You're reviewing:Spa Blower Check Valve (NON-Returnable)
Your Rating
Contact Us