SpaGuts VS300FC5 Circuit Board, 56775 (SEE REPLACEMENT BELOW)

TO PLACE AN ORDER, SEE LINK TO THE 12-200-6775 SpaGuts VS300FC5 Replacement Circuit Board, 56775.

Replacement circuit board for the SpaGuts brand SGVS300 spa controller model. Chip Number VS300FC5R1A. OEM part number for circuit board is 56775-01.

SpaGuts P/N: 10-175-6775

Circuits: Pump 1 dual speed, Ozone, 12V Light

Circuit Board Dimension (Approx): 11 inch L x 5 inch W x 1.75 inch H

This is the replacement board for the SpaGuts brand VS300FC5 or SGVS300 Spa Controller Kit 54855-01, and SpaGuts Control System 56757-01. Also replaces the balboa 54604 circuit board.

This circuit board is compatible with the 50553 SpaGuts brand Topside Panel.

This item comes with a 1-year limited warranty.

When selecting your spa circuit board, it’s critical that you go by part numbers and NOT just by appearances. The part number on a spa circuit board can be found on a white sticker located directly on the circuit board (The ID label may be located on the board relays or on the transformer). Buy based on this part number. Do NOT purchase a hot tub circuit board just because it looks the same OR have the same Model Number as the one you’re replacing. Spa circuit boards can look identical, but be programmed differently to work with different spa controllers and topside panels. NOTE that most circuit boards need to be configured in the field to work with the existing spa components and power ratings, and a licensed professional is recommended for installation and configurations. If this circuit board is being used as an optional replacement for the original circuit board, please follow the new circuit board wiring diagram for proper installation and configuration setup. Replacement spa circuit boards are shipped in clear sealed bags with Yellow Warning Label. Verify through the clear sealed bag that the correct circuit board was received prior to opening the bag. Sealed bags that are opened voids the return policy for spa circuit boards. 

CIRCUIT BOARD PURCHASE AGREEMENT: Manufacturer's Warranty DOES NOT cover burnt terminal blocks or connections, burnt or blown fuses, burnt traces or terminals for circuit board purchases. These are normally caused by field installation errors, loose connections and/or over current draw from external electrical wiring and/or components. This warranty agreement applies to ALL orders made over the phone, online orders, and through purchase orders.