Waterline Venturi Injector for Ozone with hose clamps

For spas that have a small circulation pump installed with 3/4 inch or 1/2 inch hose, you can install an ozone waterline venturi injector. This ozone venturi injector is like an inline bypass kit, but is made for installation on a small circulation pump water line. See link to the Inline bypass kit

SpaGuts P/N:

• 35-300-1130, 050 Model (Standard)
• 35-300-1131, 075 Model (Hot Springs Family)

The Waterline Venturi Injector is approximately 5.875 inches long. Both 050 and 075 models will fit on 1/2 inch and 3/4 inch hoses.

The 050 model is standard and commonly used on most spas.

*The 075 model is mainly used on Hot Springs family of spas 1995 and newer.

INSTALLATION NOTES: Basically cut in between the discharge side of the water line going to the jets, leaving a space about 3.5 inches, and install the ozone venturi injector in between with clamps. Make sure to have the arrow point towards the water flow direction. When a vacuum suction is created while the pump is running, it is ready for an ozone connection.

If there is already an ozone venturi injector installed and it is more than 5 years old, we recommend installing a new ozone venturi injector. The original ozone venturi injector would most likely be filled up with debris and other junks that will not allow a strong vacuum suction.

Ozone venturi injector includes two hose clamps.

This waterline venturi injector is also a replacement option for the following part numbers: 90-65-10185 (JED Engineering 050), 90-65-10187 (JED Engineering 075), 4-25-0054, PVDF-0684K Mazzei Injector, 6-05-0084, 684R, Del 7-0356, 6-05-0086, 9-0722-01 Mazzei Injector, 43-133-1235, 9-0722-04, 43-133-1230, 2185-220, 43-133-1240, 9-0722-06, 43-133-1225, 9-0472, 43-270-1205, 670-3010, 806105118622, 43-270-1200, 670-3000, 806105118615, 43-333-0110, AquaSunOzone 719, 43-333-0112, AquaSunOzone 715

This item comes with a one year limited warranty, and is NON-Returnable.