Waterway Executive 56 Pump Wet End ASSY

Replacement pump wet end assembly for the Waterway Executive 56 Pump model (56-Frame). Available in 2.0, 3.0, 4.0 and 5.0 HP. Select intake fitting to be 2.0 inch or 2.5 inch. All discharge fittings are standard 2.0 inch.

SpaGuts P/N:

• 15-350-1720, 310-1720, 2.0 HP, 2.0 inch
• 15-350-1480, 310-1480, 2.0 HP, 2.5 inch
• 15-350-1730, 310-1730, 3.0 HP, 2.0 inch
• 15-350-1500, 310-1500, 3.0 HP, 2.5 inch
• 15-350-1740, 310-1740, 4.0 HP, 2.0 inch
• 15-350-1440, 310-1440, 4.0 HP, 2.5 inch
• 15-350-1750, 310-1750, 5.0 HP, 2.0 inch
• 15-350-1510, 310-1510, 5.0 HP, 2.5 inch

NOTE 1: If measuring from outside thread to outside thread on the pump wet end fittings the 2.0 inch fitting will measure approximately 3.1 inches, and the 2.5 inch fitting will measure approximately 3.5 inches.

This is a replacement option for the following Waterway part numbers: 715-1201 (Drain Plug), 805-0112 (O-Ring), 819-1110 (screw), 311-1210 (faceplate, 2.5"), 311-1220 (faceplate, 2.0"), 805-0261 (O-Ring), 319-1370 (Wear Ring, 4-5HP), 319-1380 (Wear Ring, 2-3HP), 310-4210 (Impeller, 2HP), 310-4200 (Impeller, 3HP), 310-4190 (Impeller, 4HP), 310-4180 (Impeller, 5HP), 319-3100B (Shaft Seal), 315-1220 (Volute, 56Y), 313-1400 (Slinger)

NOTE 2: Only purchase this pump wet end assembly as a direct replacement to avoid leaks, fitment and failures. DO NOT install on a 48-Frame Motor.

NOTE 3: Shaft Seal Leaks are not covered under warranty for wet end purchases.

This item comes with a 90-Day limited warranty, and is Non-Returnable.