Executive-56 5.0HP 220V 2SPD SD Waterway Spa Pump, 2.0-inch Intake, 3722021-1D

In stock
In stock
SKU
15-350-0050
$494.95

Waterway Spa Pump, Executive 56 model, 5.0HP 220V 2-Speed Side Discharge with 2.0" Intake. OEM P/N 3722021-1D

SpaGuts P/N: 15-350-0050

Features:

  • 220V 60Hz 16.0/4.8A (Amp Rating Varies*)
  • RPM 3450/1725
  • 2.0" Center Suction and Side Discharge (Outside thread measures approximately 3.1 inch)
  • Dual Speed Pump (can also be wired for single speed)
  • 56-Frame Motor for added strength, cooler operating temperature and longer motor life
  • Split Capacitor, (start and run) for less energy consumption
  • Thermally protected to extend life expectancy of motor
  • UL and CUL certifications
  • Equipped with the highest quality Viton Pump Seal
  • Equipped with the high efficiency electrical motor and highperformance pump wet end
  • One year manufacturer's limited warranty on motor and wet end

*NOTE: Amp rating and dimensions may vary depending on the motor brand and model that is used with this pump. Motor brand can be US Motors, AO Smith Century Laser, GE, Etc... If space is very limited for the new pump, please check with sales to verify actual dimensions.

The pump image shows the pump discharge on top pointing to the 12 o'clock position. The pump discharge can also be rotated every 90-degrees (3, 6 or 9 o'clock positions) by loosening the four long bolts at the back of the motor. The pump intake (suction) is located in the front center face of the pump.

 

This 56-Frame pump is also a replacement option for the following pumps (Just match the size fittings and amp rating to get the same performance pump): Aquastorm by Infinity Spas, Massage Master XLT, Super-Flo, 3722021-13 (2.5" Intake), PF-50-2N22C, PF-45-2N22C, PF-50-2N22M, Dynasty 12600, 3722021-0T7GDY, 3722021-0D86, 34-270-3332 (1-Speed), 34-270-3356, 3712021-1D (2.0", 1-Speed), 3712021-0T7JDY (2.0" Intake), 372202A-1D (2.0” Intake), 372202A-13 (2.5” Intake)

This pump normally uses the following motor part numbers:

Keep in mind to not over power your spa by going from a 48-frame motorto a 56-frame motor. See water flow chart and amp rating for a 56-framemotor.

Is Your Pump Above the Water Line?

If you need to install your spa pump near or above the waterline - as iscommon for in-ground spas - you will need a pump pot.The pump pot help prevents water from draining backinto the spa when the motor is turned off

 

Write Your Own Review
You're reviewing:Executive-56 5.0HP 220V 2SPD SD Waterway Spa Pump, 2.0-inch Intake, 3722021-1D
Your Rating
Contact Us