907. SUPPORT: Instructions to Change Program Selection for Gecko IN.YE-5-H4.0 Controller, IN.K200

Instructions to Change the Program Selection for a Aeware, Gecko IN.YE-5-H4.0 Spa Controller Kit w/Topside IN.K200, Cords, 4.0KW *Changing the Program Setting to (ENTER THE PROGRAM # HERE). See instructions below: 1) See Link to the Quick Start Card: https://www.spaguts.com/Documents/QRC_YE-5_4.0KW_SOFT_355-Rev2.pdf 2) Follow Instructions on Step 3 to Enter the Low Level Programming Mode: - Note: To re-enter the low level selection menu, hold the Pump 1 key for 30 seconds. - Use the Up/Down key to choose the new low level configuration number. - Use the Light key to Save the Selection. 3) Then go back to the Quick Start Card to make sure all components are plugged into the correct location. - Look under "Configuration Selection Chart" - Then Look on the Line for your Program Selection Number (ENTER THE PROGRAM # HERE). It tells you where to plug in your component cords on the circuit board.