Articles by tag "Support"

1. 832. Support: SpaGuts VS Series Topside Panels are not responding.
   218
   You have reported that the SpaGuts VS Series Topside Panel is not responding. But the spa still run and maintains heat. Models: VS300FC5, VS500Z, VS501Z, VS510SZ 1. Connect the topside cable on the second connection. Either J1 or J2 (if available). 2. Check to make sure all pins are ...
2. 837. Support: SpaGuts Pneumatic Spa Controller is overheating the spa water.
   213
   You have reported that our pneumatic spa controller is overheating the spa water. 1) Make sure the New Hi-Limit and Temperature Sensors under the metal heater thermal cover plate are fully seated against the heater, and the wing nut is tighten. 2) Make sure the New Hi-Limit and Temperature ...
3. 856. SUPPORT: No heat on Gecko Ye-5 System with K450 Topside Panel
   205
   No heat on Gecko Ye-5 System with K450 Topside Panel 1) Check for any error message on the display of the topside panel, and if a "Wrench" icon is displayed. 2) Check to see if the the Economy Mode is activated from the topside panel. 3) Check for correct voltage to the spa. 4) Check for ...
4. 861. Support: What is the purpose of the bolt on the motor front end plate?
   236
   The purpose of the bolt and internal bracket is to further secure the front bearing to the motor front end plate. There should only be one bolt and bracket.
5. 876. Support: Air Bleeding Guide for Bath Pumps
   228
   Air Bleeding Guide for Bath Pumps: NOTE 1: Make sure the jetted bath tub is filled with water all the way to the recommended level per the spa manufacturer (above all jets). NOTE 2: Most Jetted bathtubs are indoor. When air bleeding, make sure to put in a drip pan, and clean up all water ...