Articles by tag "cs series"

1. 92. Support: Why does the light on my ozonator stay on all the time on the SpaGuts CS-Series?
   123
   On Spaguts CS-Series Controllers, the ozone circuit is setup to operate with the primary pump low speed. This means that whenever the primary pump is on low speed, the ozone unit will be active. For the ozone circuit to follow this operation, the voltage of the ozone circuit must be the same ...
2. 100. Support: My motor comes on in high speed for circulation and heating mode, and on low speed when pushing jet control button (CS-Series)
   120
   If the motor connected to Spaguts CS-Series Controller comes on in high speed in circulation and heating mode but pushing the jet control button changes the motor back to low speed, the most likely cause is that the two speed wires are reversed at the motor. Please refer to the owner's manual ...
3. 304. Support: Now nothing works off the CS-Series Electronic Controller. No display, and no functions from any components.
   136
   You have reported that now nothing works off the CS Series Electronic Controller. No display, and no functions from any components. - Sometimes, there may be a power surge at your location. Make sure all breakers and GFCI's are turned off and turned back on. Then verify that there is either ...
4. 801. Are S-Class or SSPA circuit boards by Gecko available for sale?
   103
   Note that a Gecko S-Class circuit board is proprietary to the Spa OEM Manufacturer. We are not able to get it. We only carry Gecko S-Class circuit boards that are custom-made for SpaGuts or Hydro Quip brand CS-Series spa controllers. The other replacement option would be a new spa controller ...