Articles by tag "topside"

1. 524. Support: Balboa topside displaying Pr
   98
   The Spa has just been powered up and is in Priming Mode for 4 Minutes. Pumps and Blower can be turned ON and OFF to Remove any Air from the Heater. No Automatic Functions will turn ON during this time, and the Heater will Not Start. This is Not an Error Message. Wait 4 Minutes or Press any Temp ...
2. 525. Support: Balboa topside displaying Ice or Ic
   101
   A Potential Freeze Condition has been Detected, and "Ic/Ice" in the System is being Prevented. 44°F (6.7°C) or Lower has been Detected at the Lowest Temp Sensor, or the Aux Freeze Switch has Closed, and All Pumps and Blower are Activated. All Pumps and Blower are ON for at least 4 Minutes ...
3. 526. Support: Balboa topside displaying ---F
   123
   The Actual Water Temperature is "Unknown". Priming Mode has been Exited and the Pump has Not yet run for 1 or 2 Minutes (depending on Model) to Sample Actual Water Temperature. With the Heat Related Pump Running, wait at Least 2 Minutes for the Correct Actual Water Temperature to be Displayed.
4. 527. Support: Balboa topside displaying St or Std
   104
   The Spa is Operating in the "Standard" Heating Mode. Between Filter Cycles, the Water Temperature is Sampled every 30 Minutes. The Heater and Pump will Operate Any time the Thermostat Demands Heat. The Water Temperature is Always maintained within 1°F (.5°C) of Set Temperature. Other Heating ...
5. 528. Support: Balboa topside displaying Ec or Ecn
   106
   If the Ecn or Ec Message is Alternating with the Water Temperature on the Display, the Spa is Operating in the Economy Heating Mode. If the Ecn or Ec Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Economy Heating Mode, but there is No current water temperature ...
6. 529. Support: Balboa topside displaying SL or SLP
   100
   If the "SLP" or "SL" Message is Alternating with the Water Temperature on the Topside Display, the Spa is Operating in the "Sleep Heating Mode". This is NOT an error message. Note that a Sleep Heating Mode will drop the water temperature 20 degrees below the set temperature. Please see the ...
7. 832. Support: SpaGuts VS Series Topside Panels are not responding.
   99
   You have reported that the SpaGuts VS Series Topside Panel is not responding. But the spa still run and maintains heat. Models: VS300FC5, VS500Z, VS501Z, VS510SZ 1. Connect the topside cable on the second connection. Either J1 or J2 (if available). 2. Check to make sure all pins are ...
8. 865. Support: What may cause the Topside Panel on a VS Series Controller to not work properly?
   105
   The Topside Control Panel on a VS Series Controller is water resistance, but not water proof. It also needs to be covered at all times when not in use. Harmful sun rays can affect the operation of the Topside Control Panel. With the topside buttons not operating properly, the problem can just be ...