Articles by tag "pump"

1. 57. How do I clock the pump on my motor?
   137
   Rotating or Clocking the Pump Wet End The pumps come from the factory with the discharge pointing "UP" for shipping, but they can be turned or what is called "clocked" into any position (12, 3, 9 or 6 o'clock position). Remove the back plastic motor cover (if installed), then just loosen four ...
2. 317. Support: Possible clicking noise from pump motor or controller.
   132
   - First check closely under the spa to ensure the clicking noise is coming from the pump motor or the main spa controller. - If clicking noise is coming from the main spa controller, it is possible that there may be an air lock in the plumbing lines. Contact us if so, so we can send you the ...
3. 437. Pump constantly clicking on/off continuosly (Pneumatic).
   104
   You reported that the primary pump kicks on for half a second and kicks off right away. This process is continuous. The problem can be the pump circuit triggering on/off, or it can be the motor clicking on/off. - First check to make sure correct power is supplied to the spa. For 110V ...
4. 486. Support: Water leaking from Drain Plug on a Pump (Not from Initial Install)
   108
   If water is leaking from the drain plug on a pump the problem can be from freezing, incorrect drain plug or no o-ring installed, or a problem with the pump wet end. If problem cannot be fixed, one option is to purchase a new replacement pump wet end or the complete pump. If the pump is ...
5. 504. It looks like a crack on the Waterway Executive Pump Wet End.
   124
   What you are seeing on the Waterway Executive Pump Wet End is not a crack and does not cause any functional problem. It is just a deep mark on the mold surface that create a raised area on the molded part that looks like a crack. NOTE: To verify, use a magnifying glass so that you can see ...
6. 587. Support: Wiring information for the (15-350-2293) Spa-Flo 2.0HP 220V SD Waterway Pump, 342102A-0Z.
   105
   Note that All pumps we sell have the wiring diagram on the motor. If you missed it, here is the wiring information for the (15-350-2293) Spa-Flo 2.0 HP, 220V, Side Discharge, Waterway Pump, 342102A-0Z. Motor P/N: 7-196012-03 (Customer to verify. If different, provide correct motor number for ...
7. 595. Support: Pump stopped working on VS-Series Spa Pack
   99
   You have contacted us regarding the pump on the VS Series spa pack has stopped working. Please check the following: - Are you able to run the pump on low and high speed? Or is it only running in one speed? If the pump still runs but with low water flow, respond to us for Air Bleeding Guide. ...
8. 617. How do I exchange a SpaGuts pump for a different pump?
   105
   Exchanging a recently ordered pump for a different pump can be done. However, the pump that is being returned to be exchanged MUST apply to the following conditions: 1) The returning pump needs to be in Brand New condition, Never installed, and CANNOT have any scratches. 2) The ...