1. 245. Can blower be plumbed on air venturi line?
   130
   We DO NOT recommend plumbing the blower on the air venturi line or on the water lines. Plumbing in your own air line for the blower require a lot of plumbing and can cause a major issue if not plumbed correctly, including melting the pipes, burning up the blower, and creating a short circuit. ...
2. 351. Sales: Do you sell only the circuit board?
   137
   Yes, we do sell replacement circuit boards. But we really don't recommend replacing just the circuit board. There are a lot of problems that we have seen when only replacing the circuit board. These problems consist of improper installation and mis-wiring that can cause a fire, electrocution or ...
3. 372. Spa temperature limitation.
   133
   Due to state regulations all spa controllers are limited to 104 degrees F max setting. However the system may heat over 1 or 2 degrees to keep the spa heated above 104 degrees F. Any higher temperature is consider to be health hazardous. The water in a spa or hot tub should never exceed 104 ...
4. 413. Will 208V supply be OK for a Spa Pack rated at 240V?
   125
   With 208V supply, there will be no problem with SpaGuts Controllers rated at 220-240V. But there will be a problem with the pump motors. They probably won't work properly. Pump motors rated at 208-230V are recommended.
5. 432. Gas Heater to work with non-gas spa controllers with electric heaters from SpaGuts.
   133
   Here are your choices on a Spa Controller for a Gas Heater application. 1) For Stand-A-Lone Gas Heaters that just need water flow to trigger the Ignition Switch. A) Our Non-Gas Spa Controllers come standard with an electric heater (Any of our Standard Spa Controllers on SpaGuts website). ...
6. 456. Can I use Salt with a SpaGuts or Balboa brand Spa Controllers?
   125
   Any type of Salt, including Epsom Salt, are corrosive to spa heater elements and will cause them to wear out quicker. So don't use any type of salt in the spa water without consulting with the spa equipment manufacturer. Also avoid using spa fragrances that have any type of salt in them. ...
7. 475. PayPal Payment Information
   131
   PAYPAL PAYMENT If you would like to use other types of credit cards to make a payment other than a VISA or MASTER CARD for an order, you can process the payment through PayPal. This also applies to making "Split Payments" (Either making payments with multiple credit cards or payments on ...
8. 477. Salt Water Application
   133
   When using salt, you need a 100% Titanium heater assemly to be installed on a Spa Controller. Salt corrodes the Incoloy Heater Element quickly, and slowly corrodes the stainless steal heater tube. Regular pool and spa pumps are OK with salt water application when there is good amount of ...
9. 503. What is the minimum and maximum temperature setting for the SpaGuts CS and M Series Spa Controllers?
   129
   For SpaGuts brand CS and M-Series Spa Controllers, the minimum temperature setting is 59ºF to 60ºF and the maximum temperature setting is 104ºF. Water temperature settings can be set within these ranges. NOTE: The minimum and maximum temperature setting is fixed and cannot be adjusted. ...
10. 507. Can Ozone be used indoors?
    127
    Ozone is not recommended for indoor use because of off-gasing (extra ozone) which can be harmful to your lungs. Outdoor use will allow extra ozone to evaporate in the air. If you plan to use ozone indoor, make sure there is plenty of ventilations and the ozone is properly installed. Consult ...