Before Purchase Questions

908. Support: Balboa TP800 and TP900 Topside Panel Software Setup (BP2000G1 System)

223

To change the Software Program Setup on a BP2000G1 System using the TP800 or TP900 Topside Panel, please follow the steps below: 1) Identify the Program Setup Number from the Wiring Diagram, which is located on the inside cover of the controller box. Then write that Software Program Setup ...

913. Support: New Connections or Plug-in for the 33-0025-R8 and 33-0025A-R8 Circuit Boards

194

The New Circuit Board has Part Number 33-0025-R8 or 33-0025A-R8, which is a Revision 8, a New Version that had some changes. It looks like your Original Circuit Board has an Older Revision, and you reported the Plugs for the Transformer, Flow Sensor and the Lights do not match the connections ...

926. Support: Instructions for SpaGuts CY6230 and CY6237 CY Series Controllers

227

Instructions for SpaGuts CY6230 and CY6237 CY Series Controllers 1) Please make sure to follow the installation instructions to install the spa controller and heater. See link: https://www.spaguts.com/Documents/85-0135A1_Rev.06_installation_manual(Generic).pdf 2) Then follow the wiring ...

927. SUPPORT: BP Controller display NO Comm on Topside Panel.

189

A “No Comm” is due to a loss of connection/communcation between the topside and the board. This situation may be due to a component failure; board or topside, but could also be due to a weak connection of the topside cables/extension. 1) Power down the spa. Check all the connection point ...

68. Do you carry spa jets?

194

We get lots of requests for replacement jets. They must be a hard item to find. Since we specialize in spa electrical and mechanical systems, we don't carry them. You might want to try the manufacturer of your spa or perhaps search the internet for "spa jets". If the need should ...

256. Sales: What information is needed to order a spa controller? (Controller Information)

180

To configure a spa controller, you must verify that our Spaguts spa controller will fit in the cabinet space under the spa. The dimensions of our spa controllers is approximately 12 inch long x 10 inch high x 4 inch thick. The heater attached to the bottom of the controller is 15 inch long x 2 ...

909. Sales: Information needed to locate a replacement Topside Panel.

172

To determine the correct replacement Topside Panel, please look for the Model Number, Part Number and S/N (serial number) based on the information below (Don't Just Order Based on the Appearance): TOPSIDE PANEL INFORMATION: The Model Number, Part Number or S/N (serial number) is located on the ...